How to reduce the hardness of insulated silicone tubes if it is too high?

Release time:

2025-06-21 10:30

  The production of insulated silicone tubes may be a minor mistake, which makes them too hard. What should I do? How to reduce its hardness and achieve the product's goals? The silicone tube has been made into a finished product and cannot change its hardness, that is, the hardness of the vulcanized silicone.

There are the following main methods:

  First of all, if cost factors are not taken into account, it is possible to increase the amount of oil and appropriately reduce the amount of carbon black. If a basic silicone compound has not been produced, the amount of oil should be increased in the formula. The finished silicone tube cannot change its hardness.

  Secondly, this depends on the material of the silicone tube product, so that it continues to vulcanize until it is excessively vulcanized, which can also reduce the hardness, but the performance of the product is not guaranteed.

  Third, the oven can make its surface product vulcanize back to its original state, thereby achieving the purpose of reducing hardness, but it cannot guarantee the degree index to be achieved.

  Although the above three methods are all about reducing hardness. The first method is good, but the cost is very high and not cost-effective; the second method is that the quality of the product cannot be guaranteed to be very good; the third method is feasible, but it is difficult to achieve the degree indicator.

  The insulated silicone tube has high hardness. The first thing is to check which link is wrong to prevent the problem from happening again; or is it not done well in the design stage or feeding stage? Or is it the improper molding process design leading to a change in the secondary sulfur addition process, or is it a silicone resin mixture?